0
If you mean that the shaft won't turn while the engine is cranking then check the following: Your pinion gear is stripped or the roll pin on the pinion gear is sheared...or... I'm willing to bet that your distributor is not fully seated into its socket and the pinion gear is not engaging--if the distributor doesn't seat all the way, it could be that the oil pump shaft has not engaged properly into the end of the distributor shaft and it is keeping it from seating...if this is the case, then rotate the distributor shaft by hand by turning the rotor until it catches the oil pump shaft then rotate it backwards, past the initial timing mark until the pinion hits the right position so the rotor lines up with the timing mark when the distributor is fully seated (this can take a little trial-and-error to get it ligned up right). If you mean that the whole distributor won't turn (while you are trying to set the timing) then you probably haven't sufficiently loosened the clamping bolt or you are not applying enough force.
Add your answer:
Earn +20 pts
Why wont my 1988 Firebird start the firing order is write the car just tries to turn over but will not?
Check the distributor
Why wont a distributer turn?
if your talking about when your cranking the engine over with the cap off, then you have a broken distributor gear or shaft or bad camshaft gear.
What direction does the distributor turn on a 4.3 v6?
The distributor doesn't turn, the rotor inside turns clockwise.
Your 1995 Honda civic wont start it turns over but wont start what can it be?
check the distributor
Accord wont rev past 5900 rpm when it used to go to 6500?
It's either your timing is off or you have to take the distributor cap off and set the timing again once you turn the crankshaft pulley where it is suppose to be at and set the rotor on the distributor but let me ask you if you have mess with the timing belts or the distributor cap or u took the distributor off or what?
Will your car stop runing if the distributor goes bad on it?
if the distributor goes bad then u probably wont get a spark.
Your 1997 Explorer just stopped out of no where and when you turn the key it makes the starting noise but it wont send a spark to the engine what could it be?
It could be a bad distributor or dirty module or bad timing.
You just replaced your distributor in your 99 avenger v6 and it ran 4 a lil over a week now it wont even try to turn over is this your starter?
Try jump starting.
1991 Dodge Colt how do you turn distributor to set timing?
unscrew the distributor pull it out about half way with the distributor cap off and turn the rotor clock wise to disired position
Why wont your 1988 dodge ram 318 not starting but has fire to coil but not to the distributor?
If you have spark a the coil but not the distributor, then the coil wire has failed.
Which direction does the distributor turn on a 1979 Ford mustang 5.0 HO?
Take the distributor cap off an crank the engine or turn the engine by hand clockwise and note the direction of the distributor rotor.
How do you adjustment the idle on 1992 gmc vandura 1500?
Through the carburetor or advance or retard the distributor by turning the distributor cap barely left or right. If you cant turn it then loosen the bolt holding the distributor on to the intake with a wrench then turn the distributor til the engine sounds like its not missing or not to where it's about to turn off.
