Put it in park , insert the ignition key into the ignition and turn the key to start it.
get the key and insert said key to ignition, once inserted turn ignition to the right and BAMM your on your way.
Its where you insert the key
The ignition switch is where you insert your key to start car
To remove the ignition switch in a 1981 Corvette, insert the key into the ignition while leaving it in the "off" position. Insert a straightened paper clip next to the key, turn the key to the "Acc" position, pull the key and clip out together, and place the coil down.
To remove the "key" ignition, insert a small screwdrived in the hole directly below the ignition in the column. You will need to have the key in the ON position otherwise the ignition will not come out of the column.
Well, I don't see that it would help it any! There are 2 keys for a reason! Why would you want to insert the door key in the ignition? It surely won't start the vehicle! Unless the ignition is already screwed up and can start with anything! The tumblers in the the locks for the ignition and doors are different! It would be like putting your house key in the car! Won't work!
Programming a new cut key is easy. Take the original key and insert it into the ignition switch and turn the ignition on. Then, turn it off and remove the original key. You then have 15 seconds to insert the new key and turn the ignition on. Leave it on a few seconds and then turn it off and remove it. That's it. You should be good to go with the new key now. I was.
The ignition switch is in the steering column..that's where you insert the key to start the vehicle.
wrong vehicle.... check the other one
insert the key in car ignition, turn the key, put it in gear and lastly press hard on the gas
1. Close the vehicle doors.2. Turn OFF the ignition.3. Remove the key from the ignition.4. Press and hold the driver side door lock switch in the UNLOCK position.5. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)6. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)7. Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.) Leave the ignition key in the ignition lock cylinder.8. Release the door lock switch. The vehicle will sound three beeps in order to verify the Program Mode has been activated.9. Press the LOCK and UNLOCK buttons together on the keyless entry transmitter and hold until the vehicle beeps twice to verify that the transmitter has been successfully programmed (this take approximately 15 seconds).10. Perform the previous step to program up to four transmitters (including your old ones).11. Remove the ignition key in order to exit the Program Mode