Ignition switches of that era had problems . Make sure gear selector is hard in Park and try again. If necessary spray a lubricant in the ignition keyhole.
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
A 1998 Ford Taurus uses the Electronic Distributorless Ignition System ( EDIS ) with a coil pack , so there is no distributor
The heater switch is located in the middle of the car in the 1998 Ford Taurus. It is either above or below the radio.?æ
1998 Taurus pressure sensor location; It is located on the firewall side between the head and the transaxile housing.
On a 1998 Ford Taurus : The fuel pump shut off switch ( inertia switch ) is located in the trunk , on the passenger side , behind the trunk liner ( there is an access hole )
No, there is no kill switch except for the ignition switch.
How_do_you_remove_the_key_cylinder_in_a_98_Toyota_tacoma
the wire is Yellow coming out of the ignition switch going to the Neutural safety switch, then purple from the neutual safety switch to the starter
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
It may have to do with the locked steering feature of your car. Try turning the wheel one way or the other while you turn the ignition.
air conditioner not working on off switch
Defective ignition switch.