left side under the vehicle directly under the driver seat.
I have a 1995 buick centruy and I can move the gear shift lever, but cnnot get the car to move in drive. I have checked the fluid level and it is okay. Is there a cable that is loose or out of adjustment ?
How to transfer an elevation with an automatic level
It's under the back seat next to the battery. It's called the "ELC" (Electronic Level Control) . Micro relay 55
because it contain a magnifying glass....
Q.construct a ladder diagram for automatic level control of on roof reservoir for the following two condition. 1)whan water level is below the lower level,switch of the pump should turn on. 11) when water level touches the upper level,the pump should turn off ;it should remain off until the water level reaches below the lower level .
It is located at the rear of the van on the driver side behind the gas tank
It depends on what is broken. Mine has a seized compressor. There are a few places that sell a replacement. I just have not spent the money to fix it. They're about $200 mail order.Many times, the ALC stops working because the switch attached to the Left Rear suspension stops working. The switch is fairly inexpensive
The Sony TCM-150 Cassette Recorder with Automatic Recording Level Control is available in your price range
This product is designed to automatic control of motor, which ensures constant reserve of water in storage tanks. Automatic water level controller is used to automatically fill the over head tank as and when it gets empty and monitor the water level in it. Automatic water level controller switches ON the motor when the water level in the overhead tank drops below pre fixed low level(on point) and puts off the motor when water level rises up to pre fixed high level (off point) motor also switches off when the sump water is exhausted before filling overhead tank, pump running dry, Mains voltage fluctuations.
This product is designed to automatic control of motor, which ensures constant reserve of water in storage tanks. Automatic water level controller is used to automatically fill the over head tank as and when it gets empty and monitor the water level in it. Automatic water level controller switches ON the motor when the water level in the overhead tank drops below pre fixed low level(on point) and puts off the motor when water level rises up to pre fixed high level (off point) motor also switches off when the sump water is exhausted before filling overhead tank, pump running dry, Mains voltage fluctuations.
Oil level sensor is on side of oil pan.