answersLogoWhite

0


Best Answer

The blend door is on a vertical axis in the Explorer and it sounds like when you set the fan to high, you are blowing the door to a position where the heater core is open. The root cause of the problem is a broken blend door. Once the door breaks, it "blows in the breeze" and there are different combinations of turning corners hard, hitting bumps, changing fan speed, switching mode, etc. that will get temporary heat. The blend door has to be replaced to regain control of the system. This is a common failure on the Explorer and is an expensive fix at the dealer. Follow my user name to my Bio Page for a pointer to the HeaterTreater web site. This site has diagnostic information on this particular problem and an inexpensive fix. ford4me

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does 2000 Eddie Bauer explorer heater only works on high?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happened if after the mechanic fixed the air conditioner the heater no longer works in a 2000 Eddie Bauer Ford Explorer?

The most likely answer is that he disconnected a wire that he did not reconnect. You should take it back to the shop and let him reconnect it. He will know exactly where that wire is because he has done it many times.


Can the glove box key be used to cut a new ignition key for the 93 Explorer sport Eddie Bauer?

Try it in the ignition and see if it works. I sold my 1993, but I am pretty sure it cannot.


1996 Eddie Bauer left side no low beam but hi beam works?

Have you checked the bulb , it has 2 filaments in it , see if one of the wires is broken


Why does the 2002 ford explorer keep blowing heater hoses?

could be head gasket problem. does your heater work? might need heater core , clogged up. do compression test. or bypass heater core and see if that works.


How do you find out if the horn is bad on a 1995 Ford Explorer Eddie Bauer edition?

Run a direct wire from the battery to the horn, if it works the problem is in the horn button or the fuse. On second thought, use a test light to see if the horn wire is getting power when the horn button is pressed. If it is, make sure the horn has a good ground. If everything checks out, replace the horn.


Is there a headlight fuse on a 1998 ford Expedition Eddie Bauer only one low beam works but both high beam works?

Try changing the bulb that doesn't have the low beam. Check at your local auto parts store for the correct bulb.


Where is the ac resistor located on 2001 expedition?

the ac only works on high the AC blower motor resister is located behind the pass. side kick panel's. just ahead of the door. this only applies to Eddie Bauer's. all others are on the side of the blower motor housing behind glove comportment Eddie Bauer us a solid state type 2"x2"x1" box. if the AC only blows on high the most likely casuse is an open inside the restior.


If the rear AC on a 1997 Eddie Bauer Ford Expedition works but the front AC does not what could be the problem?

The problem is probably in the mixing door not operating properly. It could be in the control panel or the door itself. It just has to be checked out. GoodluckJoe----------------------------------------------------------------------; Blend Door Actuator


Heather control in 2004 ford explorer?

The heater control works along with electrical controls to properly operate the heat. If the unit is electronically controlled, then computer codes can be checked to see if there may be a problem.


If the heater works but blows cold air and heater core is good what do i check next?

Get the air out of your heater core.


Heater only works on high speed?

The heater motor speed resister is burned out.


How room heater works?

BY CONVEntional current