answersLogoWhite

0


Best Answer

If you have to pump your brakes this is serious. Check the fluid level and if it is low, add fuild to the full mark. If this does not help, you need to repair you brakes immediately. You may need pads, or you may have other problems. Inspect them ASAP.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why do I have to pump brakes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is my power steering pump plumbed into my brakes?

The power steering pump also provides power for the power brakes.


Should you pump your ABS brakes to stop you vehicle in adverse conditions?

No, the purpose of anti-lock brakes is to prevent your vehicle from skidding in adverse conditions and during an emergency maneuver. The system will pump the brakes for you.


In a vehicle equipped with Anti-Lock Brakes pumping the brakes will?

Be pointless. The point of anti-lock brakes it to effectively "pump" the brakes for you.


How do you adjust brakes on hyster fork lift?

I have to pump my brakes what čould be wrong


Jaguar Xj6 1989 has no power brakes what could it be?

There is a device that works with your brakes to help the brakes,it is a servo pump that has gone out on your car. Mine went out too but I am strong so I just use the brakes without the servo pump.


Your car will not brake with new brakes?

Well before you go out and get factory brakes i wood try and pump your brakes before you going driving the car, pump at least 10 times or more to be safe.


When braking in a slippery road what do you do?

Pump the brakes gently


When do you pump brakes after changing pads?

Bleed brakes after changing pads to extract any air bobbles.


Is it the vacuum pump or steering pump that's bad if you lose brakes and steering same time?

power steering pump


How do you bleed the brakes on a 2000 Toyota Tundra?

To bleed the brakes on a 2000 Toyota Tundra, first pump the brakes, then loosen the drain plug on the master cylinder and pump another 3 to 6 times. Tighten the plug and add brake fluid.


After replacing front pads and rotors do you still need to bleed the brakes?

No you dont have to. All I did was was pump the brakes with the car running


Why does your cars steering wheel so hard and also the brakes on a Chevy astro?

The Astro Van power steering and brakes work off the same pupm. Check the pump for fluid. If it's full and the brakes and steering still hard you must replace the pump