Most of them are behind the glovebox on the heater enclosure. You may have to remove the heater control and/ or radio if that is in the way. The hard part is getting to it; they are usually held in place by a couple of screws and just plug into a connector. I hope this helps you. Mark
>>> Its behind glove box and behind blower motor its has cable divided from blower cable & cable to resister box, Its black box ( u can see cable going in ) attached with 2 screws , its behind blower motor towards front side
>> u have to remove cover on left passenger side ..
how do i change my blower motor on my 2007 malibu
Under the passenger side dash. It's awkward to get to, but it's there.
if you lost one or two fan speeds you need to change the blower motor resister. it sells for around $60.00 at a dealer only.
Open hood, locate resister on passenger side of firewall, unplug the electrical connection, remove the three screws and remove resister.
if it is the same number on it!!
AutoZone.com will show you a pic.............
usually mounted on or next to blower motor
Remove the HVAC rear module auxiliary assembly.Disconnect the electrical connectors from the rear blower resister auxiliary.Remove the air outlet duct from the rear blower motor controller auxiliary.Remove the screws from the blower motor rear resister auxiliary.Remove the rear blower motor resister auxiliary.Replace the resister and install new thermal gasket.................
Replace the blower motor speed resister.
The blower motor is under the glove compartment
Probably your blower motor speed resister is burned out.
Under the hood, passenger side firewall, close to the heater blower motor.