answersLogoWhite

0


Best Answer

The timing marks should be dot to dot.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where should the timing marks be relevant to the timing chain on z24?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1998 chevy vortex engine have two timing marks?

There should be advance marks on the harmonic balancer, and timing marks on both timing chain gears.


Timing chain marks for 96 maxium?

what the timing chain marks for 96 maxium


Does the marks have to be right on a 2004 Chrysler sebring?

If you are aking about the timing marks on the belt/chain. Then yes.If you are aking about the timing marks on the belt/chain. Then yes.


You just replaced the timing chain in a 1996 Nissan truck 2.4L and you are having trouble setting the timing any suggestions?

There are marks on the chain that coordinate with marks on the timing gear. Make sure these line up when putting on the timing chain, and you should be good to go. Getting to the timing chain is the real battle.


Timing marks for 1998 grand am 3.1 motor?

where are the timing chain marks


What are the timing marks for a 1951 Dodge Coronet flathead 6 motor?

The timing should be set at TDC (Top Dead Center). The timing marks are located on the vibration damper and timing chain cover.


Where are the timing marks on a Chevy 305?

On the front of the timing chain cover, drivers side towards the top of the harmonic balancer.


How should the timing marks line up on a 1969 Ford 360?

The timing marks on a 1969 Ford 360 should line up between the timing chain and the cam sprocket. This sets the initial timing which can later be adjusted using a timing light.


Timing chain marks on 2000 Ford Ranger?

3.0 liter timing chains marks


Nissan 1.6l timing chain marks?

95 200sx Nissan 1.6l timing chain marks? The haynes manual diagram sucks


Where are the timing marks on a dodge Dakota 4.7 v8?

The chain alignment marks are on the chain and the sprockets.


Timing chain gear alingment 3.1L vin M?

There should be timing marks on the block, set your cylinder to TDC and you should be able to time it