if it has the plug in the back of the truck for trailer brakes then it is under your dash. it should be a female plug. about in the middle of the dash(more twards the left) you can get a plug from Ford that plugs right in and it will have leads off of it to wire right to your brake controller. makes it super easy
This site will show you exactly where the connection is and what you will need. http://www.etrailer.com/faq-cbc.aspx
There is a connection issue between the trailer brake controller and the trailer.
When one is using a trailer on their car, an electric brake controller measures the car's braking speed and adjusts the electric braking power of the trailer to correspond. This helps avoid collision between trailer and car.
should be down by steering column.check owners manual.
Wheri trailer connector on 2004 suburban
Yes.
On a 2003 Lincoln Navigator : Fuse # 29 is a 30 amp mini fuse for the trailer tow electric brake controller , trailer tow 7 wire connector ( electric brake )
You should have a trailer brake control module (either OEM or aftermarket installation) if it is.
Sounds like a weak ground connection somewhere on the trailer or tow vehicle.
Yes, but your ABS will not function if you should need it.
Most trailer brake controllers require 3 or 4 "inputs" and have 1 output. Ground, any point on the vehicle metal frame. Power, any fused connection that provides power when the key is on. some controllers don't use a power connection. You'll need to refer to the owners manual that came with the controller. Brake light, a signal from the brakes indicating that the brake pedal has been depressed. The output goes to the trailer plug pin that controls your trailer brakes.
The trailer brake wiring connection is part of a complete trailer lighting and breaking system. The harness plugs into an adaptor near the spare tire behind the license plate. For More information READ THIS: Where%20is%20the%20factory%20connection%20for%20a%20trailer%20brake%20harness%20on%20a%202001%20ford%20F250%20SDNot exactly the answer to the question...The brake controller harness plugs into a grey colored connector located under the large removable plastic cover just below your steering column. It is to the right side of the column.