0
Temp is controlled by a blend door in the ducting in the passenger side. A small motor opens and closes the door to regulate heat in cab. The motor arm fits in a square hole in the door, the common problem is the square hole breaks out, and the door needs to be replaced.
Add your answer:
Earn +20 pts
Where is heater control valve located on 1992 ford E350?
In my 98 E350 6.8 it is under the dash. you have to pull the dash off to change it
Where is the location of heater control valve on 1998 ford windstar?
The "Related Question" below is an extensive discussion on the 1999-2003 temperature control valve / heater control valve. It is likely the information will be similar to the 1997 / 1998 Windstar
Where is the low pressure valve for recharging the air conditioner on a 1999 ford e350?
I need a diagram on where is the low pressure valve on a 1999 expedition
Where is the heater control valve for a 1997 Ford Expedition located?
where is the heater control valve for a 1997 ford expedition
Where are the glow plugs on a 96 ford e 350?
glowe plugs on 1996 ford e350 .7.3 diesel are under valve cover
Where is the roll stability control censor on a 2008 Ford E350?
under the driver seat.
Where is the air conditioner recharge valve for a 1991 Ford E350 with a 300 six cylinder?
This is not a job you can do at home so where the valve is doesn't matter. Take it to a shop.
What temperature does the Ford E350 diesel 6L fan clutch activate?
230 deg. F.
Where is the orifice tube on 1999 ford e350 rear ac?
its an expansion valve and it is located in the black box ( in the rear unit)
Where is the heater control valve on a Ford Taurus located?
The Taurus does not have a heater control valve. Coolant flows through the core at all times. Be sure to review the "Related Question" below for much more about Taurus temperature controls
Where is the vacuum control Valve located on a 2002 Ford Explorer?
Need to know which one you are looking for or, what does this vacuum control valve control.
Where is the idle control valve on a 2005 ford E350 with a 5.4?
on the top rear area of the air plenum. the engine cover has to be removed to access it..2 bolts,(1) 2wire connector and 1 lg vacuum hose is attached to it
