Not to be mean, but if you cannot find the starter I would recommend you find a shop for repairs. Now that being said. Jack vehicle up as if you were going to change the driver front tire. Recommend you put a jack stand under that side of truck. Go under the truck from that side. Locate the rear of the motor/front of the transmission where they are mated. The starter is the only item attached to the motor that low on the motor. There will be a large red wire going to the starter. (Power from battery)
What size starter bolts for an 1993 Ford F250 4x4 automatic
for answers go to pinkworld.com
On the drivers side on the bottom of the engine, it has a red wire going into it.
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
1993-1996 automatic transmission: MERCON automatic transmission fluid (NOT MERCON V) 1993-2005 manual transmission: MERCON automatic transmission fluid (NOT MERCON V)
how to i change a clutch in a 1993 ford ranger
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove starter mounting bolts Twist starter to remove
For a 1993 Ford Ranger , 5 speed manual transmission : ( trans code " M " / Mazda ) It takes 2.8 U.S. quarts of MERCON automatic transmission fluid
1993-2005 Ford Ranger V6 3.0L engines are equipped with a timing chain. - Haynes Repair Manual #36071
The engines in a 1993 Ford Ranger are fuel injected , so there is no carburetor
diagram of starter in a 1993 ford probe
Yes, a 2003 Ford Ranger tailgate will fit a 1993 Ford Ranger. As of July 2013, the average price of a new tailgate for a Ford Ranger is around $160, plus tax and shipping.