If it's anything like my 98, you have to get to it from the drivers side top and underneith the car. 2 people make it very easy. there are 2 bolts near the firewall side of the bell housing that hold the alternator in. From the bottom you will see the starter on the back side of the motor, near the shifter linkage ( manual trans ) look straight up and slightly to the drivers side. As you parter un bolts it ( 12mm or 10 mm can't remember, also some U-joints and extentions help when using a ratchet ) you hold on to up from underneight, as not to stress the bolts. After that it just drops down. Unsure if the 96's have this "A" looking brace that supports the intake manifold, mine did and it makes it very hard. I took mine out as I saw no EXTREME use for this thing. There are to more smaller braces that hold the intake manifold on from the front so I saw no use for it. BTW it's very hard to manuver out. Becides that alternator shouldn't be too hard. :)
Where is the starter to a Nissan 200sx
$125 to $140
YES ... you don't even have to read to much into the book to find out either ... It says it on the cover of the manual it's for a 1996 Nissan 200sx ES ...
If you have a automatic it is located under your intake manifold.Answeri have a 1.6l 1995 Nissan 200 sx se manual trans its located right under the air entake box for fresh air
replace 1996 nissan 200sx se 1.6 tension pulley
no such relay.
how do i fill my trans fluid in 1996 nissan 200sx 1.6 l manuel trans
115
Follow pos batt cable to the end. it is in flywheel/trans area under pass side bottom.
GA16de
My 1996 200SX SE holds 12 gallons of fuel.
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.