answersLogoWhite

0


Best Answer

I have a RV built on a 1994 E-350 Ford chassis with the 7.5 liter engine. I finally found the SPark OUTput (SPOUT) connector behind the driver side battery. It is a gray plug in a black socket. It was taped to the wiring harness that goes to the ignition control module (ICM) which is also behind the battery. The tape completely covered both the plug and socket making it very hard to find.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the spout connector on a 1996 ford e350?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a inline spout connector?

wer is the spout connector on 1992 ford e150 v8 5.0 liter


Where is the SPOUT connector on 1997 ford ranger 4.0L V6?

I'm not a mechanic / technician but I believe the spout connector is by your COIL PACK


Where is the spout connector on 1992 ford f-150?

where is the spout control on a 1992 ford f150 300 6 cyl


Where is the spout connector on a 1997 ford contour 2.0?

um just no


Is a 1996 Ford E350 with 460 cid fuel injected?

Yes


Where is the spout connector on 1990 ford f150 5.0 liter?

I believe it should be close to the distributor at the front of the engine


Where is the spout connector located on a 1993 Ford Thunderbird?

Its located on the passenger side fire wall near the shock tower


Where is spout connector on ford 5.8L F-250?

Driver side left fender about 8 inches below and left under diagnostic connector if your standing over it. Its grey.


Where is the spout connector on a 94 ford ranger 3.0?

its located just forward of the battery and just behind the left headlight. it has pink wires.


Where is the voltage regulator located at on a 1996 ford e350 diesel?

Usually inside the rear section of alternator


Where are the glow plugs on a 96 ford e 350?

glowe plugs on 1996 ford e350 .7.3 diesel are under valve cover


Where is and what does it look like the inline spout connector on a 1995 ford F-150 4.9 liter motor?

i have never heard of a spout connector. need more information - Its a little square gray plug with 2 wires going into it usually taped to the wires that go to your ecm - hope that helps