answersLogoWhite

0


Best Answer

It should be mounted into the drivers side rear of the transmission.

User Avatar

Wiki User

βˆ™ 15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the speed sensor on a 99 Chevy s10 pickup?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the vehicle speed sensor on a 1995 s10 pickup?

The vehicle speed sensor on a 1995 s10 pickup 2wd is on the tailshaft of the transmission. The 4wd is mounted on the tailshaft of the front differential.


Where is knock sensor located 1998 Chevy s10 pickup?

We will need to know which engine it has to answer that.


Where do you put coolant in 1994 Chevy s10 pickup?

where do i put coolant in for 1994 Chevy s10 pickup


Will a 96 blazer transmission fit a 95 s10 pickup?

Will a Chevy blazer engine fit in a Chevy s10 pickup


84 Chevy pickup coolant sensor 6 cly location?

where is the coolant sensor on a 1984 s10 blazer 2.8 6 cylender


Will a 95 blazer transmission fit a 96 s10 pickup?

Will a Chevy Blazer engine fit in a Chevy s10 pickup


Does the vehicle speed sensor control the idle in a Chevy blazer s10 1989 2.8?

No it does not.


Will the speed sensor in a Chevy s10 blazer make the truck not shift?

That is True.. A faulty speed sensor will cause no shift or late shift..


Does a 1994 Chevy S-10 have a Speed Sensor or a Cable?

I have a 91 s10 and it has a speed sensor. It is located at the rear of the tranny on the drivers side


What is the payload for a 1985 Chevy S10 Pickup?

The payload for the 1985 Chevy S10 pickup is between 1000 and 1500 pounds depending on the exact model. The S10 is the smallest of the Chevrolet pickup series.


Where is the oxygen sensor on a 88 Chevy s10 pickup?

it should be located on the front exaust pipe before the cat converter.


How do you change the speed sensor on 1991 Chevy S10 pickup?

Unplug the electrical connection to the VSS (Vehicle Speed Sensor) located on the drivers side of the tail shaft housing of the transmission. Remove the small bolt and clamp holding VSS in place. Wiggle the sensor out of the housing. Install in reverse order.