answersLogoWhite

0


Best Answer

The slave cylinder is actually built onto the throw-out bearing. If you have a problem with it you will have to pull the trans.

User Avatar

Wiki User

βˆ™ 18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the slave cylinder on a 94 Chevy S-10 pickup?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?

how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder


How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?

You will need to remove the transmission to replace the clutch slave.


Where is the slave cylinder at on a Chevy 1991 S10?

Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.


How many spark plugs does a Chevy s10 pickup have?

One per cylinder, a four cylinder has four, a six cylinder has six and so on.


Where is the slave cylinder located on a 2000 Chevy S10?

The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.


Where is the slave cylinder on a 2002 Chevy S10?

the slave cylinder is bolted to the drivers side of the transmissions bellhousing,the reservoir for it is on tne drivers side firewall


Where do you put coolant in 1994 Chevy s10 pickup?

where do i put coolant in for 1994 Chevy s10 pickup


What is the coolant capacity for a 1994 Chevy S10 pickup 4 cylinder 2.2L?

Aprox 11 qts.


Will a 96 blazer transmission fit a 95 s10 pickup?

Will a Chevy blazer engine fit in a Chevy s10 pickup


Where is the 1 cylinder on a 2001 Chevy s10 pickup?

If its a 4 cylinder its the very front toward radiator, if its a v6 its the very front cylinder on the drivers side


How and where do you change a slave cylinder for a 1993 Chevy S10 manual pick up?

The slave cylinder on my s10 in on the driver side of the transmision. There are only 2 nuts that have to be removed to take the slave cylinder off. Then u must take out the pins to remove the clutch line.. Hope this helps


Does a 1995 Chevy S10 4 cylinder Pickup have a triming belt or chain?

Timing CHAIN on your 2.2 liter