answersLogoWhite

0


Best Answer

Attempt this first since the switch costs nearly $300 bucks.

On the passengers side of the trans just behind the bell housing there is a fan shaped switch, loosen the 12mm bolt ( smaller of the two, and rotate the switch while a friend checks the lights. this problem is usually accompanied by an occasional inability to start the vehicle, but can be cured by jiggling the shifter.

While adjusting the switch make sure that the vehicle will start in park as well, remember to block the wheels while testing the back up lights, engine off, key in run but not start, shifter in reverse, move switch until lights come on.

Once you find this spot, hold it in place and have your helper check to make sure it will start. This may take several tries to get both working correctly.

If you have no luck the switch may be dirty, this happens a lot. Hold the post to the bottom large bolt still while you loosen the nut, then remove it, then remove the 12mm adjusting bolt on top, remove the wire connector and pull the switch away, remove the bolts on the switch and separate the halves, use electrical contact cleaner and maybe some q-tips to clean all the copper connections completely apply di-electric grease and reassemble, refit to the trans and readjust so all functions work, this switch controls back up and start safety.

Caution! always hold that bottom bolt while tightening the large nut, this is connected to the gear adjuster and you could damage the internals if it isn't secured while you do it.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the reverse light switch located for a 1992 Jeep Cherokee?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the reverse light switch located on a citroen c2 vtr?

Where is the reverse light switch on a CiTREON C2


Where is the backup light switch on a jeep Grand Cherokee?

I was told by my parts guy that the back up light switch is the same as the reverse light switch.


Where is the reverse light switch located on a 99 vw jetta with a stick shift?

where is the reverse light switch located on a 2002 jetta with a stick shift


Where is the reverse light switch located on a 1993 Mazda 626?

The 1993 Mazda. reverse light switch is located below the shifter column. The relay switch can be seen by removing the center console.


Where on the transmission is the reverse light switch located for a 1996 Plymouth Voyager?

the reverse light switch is usually mounted on the shifter inside the car.


Where is the reverse gear light switch located?

It is important to know the location of the different car parts. The Reverse Gear Light Switch is located on top of the gearbox in most cars.


Were is the reverse light switch located on a 1980 camaro?

its located on the trans .. its a plug .


How do you change brake light switch on 93 Jeep Grand Cherokee?

The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.


Where is a 94 Grand Cherokee backup lite switch location?

The reverse light switch is part of the neutral safety switch. It is located on the left side of the transmission just above the pan. It has three wires and points towards the left rear tire.


Where is the Location of reverse light switch on 2002 dodge ram standard?

The 2002 Dodge Ram reverse light relay switch is located beneath the drivers side dashboard. The reverse light relay switch will be on the left-hand side of the brake pedal.


Where is the reverse light switch located on a 2004 Mazda 6 with a manual transmission?

the reverse light switch.. aka backup light switch is located on the front of the transmission along the side screws into the transmission if standing in front of the car looking down at the transmission you can see it


I have a 1997 Jeep Cherokee the reverse lights on work sometimes is there anything I can do to make them work all the time?

check the reverse light switch and all connections