0
It's in the low pressure line running along the passenger side of the engine compartment. If there is a connection there with a nut, it's inside the tube there. If the line has no connection, it is crimped in and that section has to be cut out and replaced with a repair kit, or a new line installed.
Add your answer:
Earn +20 pts
Where is the mass air flow sensor on a 1998 mercury villager?
In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.
Where is the starter located on 1998 mercury villager?
Top rear of engine directly under the air intake tube/throttle body.
Where is the orfice tube in a Ford Taurus?
Where is the orfice tube in a Ford Taurus
Where is the rear ac accumulator located on a 1998 venture?
There isn't a rear accumulator. There is a rear orfice tube and evaporator.
Where is orfice on Ford Windstar?
The orfice tube is located in the evaporator inlet tube. There is also an expansion valve in the rear evaporator case.
Where is the orfice tube located for a 1998 Chevy Express van?
It is at the output of the condenser. Remove the passenger turn signal lense to access it.
Where do you put transmission fluid in a 1997 Mercury Villager?
Down same tube that holds trans dipstick.
Where do you add transmission fluid for 1997 mercury villager?
Transmission fluid is added through the dipstick tube.
Where do you add transmission fluid on mercury villager 1997?
Transmission fluid is added through the dipstick tube.
Where is the IAT sensor for 2001 Mercury Villager locaed?
Located in the air intake tube beside the battery.
What is the size and length of the egr tube on a 1995 Mercury Villager LS?
This is a custom bent tube with flared ends. It would be hard to duplicate. I believe it's a 1" tube.
Where is thermostat on 1995 Mercury Villager?
At the front of the engine under the housing that attaches to the coolant crossover tube assembly.
