0
Add your answer:
Earn +20 pts
Where is the EGR valve located on a 1996 Ford Ranger 2.3?
egr valve location on a 1997 ford ranger 23l
How do you rebuild a 1988 ford ranger 23L engine with fuel injection?
Take it to jasper they rebuild any motor.
Is the neutral start switch the same thing as the neutral safety switch on a 1997 ford ranger 23l 4cly?
yes
Where are the vacuum lines on a 1987 Ford Ranger with a 23L with fuel injection located at?
they stems from the intake manafold then run in several places
What is the firing order of a 93 Ford Ranger 4 cylinder 23L and how are the cylinders numbered on the block and where would the 1 plug wire be located on the distributor cap?
23L 4cylinder motors dont have distributors the cylinders on the block are numbered (front to back) 1234 and the firing order is 1-3-2-4 Correct Firing Order: Correct firing order is 1-3-4-2; Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups
What is the oil capacity of a 23L 4cyl 1993 Ford Ranger 5spd 2wd?
The engine oil capacity for the 1992 2.3L is 5 quarts (includes filter).
What is the firing order for a 1993 ford ranger 23L?
Here you go: Copy & paste into your browser: http://autorepair.about.com/library/firing_orders/bl-fo-7923.htm
How do you change the clutch in a 93 ranger 2wd 23L?
i called the ford dealership they recominded that u not do it yoursealf unless you had a full shop worth of equipment i have a 93 ford ranger 2.3L 5speed and i had it done by a local mechanic for 300 i bout the parts myself it was worth it..
How do you find the firing order for a 19'93 ford ranger 23L?
Here you go: Copy & paste into your browser: http://autorepair.about.com/library/firing_orders/bl-fo-7923.htm
What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?
bad crank shaft position sensor
Where is the PCV valve located on a 97 Ford Ranger 23L?
The PCV is located on the driver's side of the engine. It is at the same level as the spark plugs, in the middle of the engine. It is not seated in the oil cover. It is seated in the oil diverter.
What would cause your 96 ranger 23l to backfire through the breather?
More than likely it has jumped time. This is a comman problem with older timing belts. Or in colder weather.
