answersLogoWhite

0


Best Answer

The knock sensor is located on the left side of the block. Often the steering shaft will contact and wrap the wiring harness around it, braking the connector. You should check this first, before replacing the sensor.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor on a 1991 Olds Cutless Supreme?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Location of knock sensor 1991 GMC sierra?

Location of knock sensor 1991 GM sierra 350 2500?


Where is the knock sensor on a 4x4 1991 Ford Explorer?

There is no "knock sensor" on a 4.0L engine


How do you repair the timing on a 1991 Oldsmobile Cutlass Supreme 3.1 liter V6?

You can't, its done by the computer if you have a knock noise, replace the knock sensor. its locate on the back of the engine near the alternator.


What is the function of a knock sensor on a 1991 4.3 s10?

The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.


Where is the knock sensor on a 1994 Jeep Cherokee Sport 4.0?

There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.


Where is the knock sensor in a 1991 Chevy Silverado?

It is screewed into the passenger side of the engine, just in front of the starter.


Where is the knock sensor on a 1991 300zx 2 2 non turbo?

The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.


How many sensor is on a 1991 Toyota Cressida?

There's many sensor, O2 sensors, (Palet type ) Airflow sensor, Throttle body position sensor. Knock sensor and probably much more for brake, speedo and transmission.


What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?

the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.


Where is the crank sensor in a 1991 Cutlass Supreme?

Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.


Where is location of knock sensor 1991 Toyota truck with 3.0 3VZ-E?

The knock sensor is located in the block, under the intake manifold. You have to basically remove the top end of the engine to get to it. The pigtail which connects the sensor to the harness is usually the culprit. It is notorious for failing but after spending all the time and money for gaskets I would recommend replacing the sensor as well.


How do you change a knock sensor on 1991 Chevy 350?

Make SURE the engine is COLD. Then unscrew the old sensor and install the new one. Antifreeze will leak out of the engine so be quit when replacing it.