0
Add your answer:
Earn +20 pts
Where is the carburetor idle adjustment on 1987 Honda Goldwing Interstate?
If you look on the foot brake side, just where the cable meets the carb, there is a screw a little further in, that will adjust the idle. Use a long screw driver.
Where is the idle adjustment screw on a 1987 Dodge Ram 50?
its on the driver side of the carb down at the bottom in the middle there is a metal plug you have to drill out to get to the screw
What would cause a 1987 Chevy s 10 to die while in idle but not die when excelerating?
carb problems, adjust the idle screw and see if that helps
Where is the idle adjustment screw on a 2001 Mazda millenia v6?
On the 2.3 liter it is between the rear intercooler air duct and the ABV,it is a large,silver screw on top of the throtte body.
How do you adjust idle on a Honda XR80?
Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.
Where is the Idle screw on a 1990 le baron?
Idle is computer controlled, no adjustment screw.Idle is computer controlled, no adjustment screw.
How do you set the idle on a 1987 Virago 535?
Hey you need lift the engine up and underneath the engine and there wil be a cap it says idle you want to pull that off and turn the screw with a screw driver i had one of these very good vehicle. hope this helps
How do you set idle for ATVs?
There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.
Where is idle screw on impco model e?
A model E converter does not have an idle screw. Your idle adjustment would be on your Mixer, equivalent of the carburetor.
Where is the idle screw in a 1999 yz 250?
twist the top of the choke, there is no idle screw on the 1999 yz250
Does a 1997 dodge ram van 2500 have an idle screw and where is it?
Idle is computer controlled, there is no adjustment screw.
How to adjust idle on toro push mower?
The idle on a Toro push mower can be adjusted by turning the screw located on the carburetor. Turn the screw to the right to gain idle speed and turn the screw to the left to diminish idle speed.
