The blower motor resistor is defective. They go bad when the blower motor pulls to much amperage.
how do i change my blower motor on my 2007 malibu
In general the heater blower motor speed resistor is located in close proximity to the blower motor.
Assuming you're talking about the blower motor, because the blower motor resistor is faulty, and needs to be replaced. On the high setting, it doesn't go through the resistor - on the other settings, it does.
In general, the blower motor resistor is located close to the blower motor.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
They generally locate the heater motor speed resistor nearby the blower motor because the resistor depends on the blower to keep it cooled.
For the 1989 Dodge Ram, the heater blower motor resistor can be found on the passenger's side, on the bottom of the heater box. It is beside the blower motor.
You'll find the heater blower motor resistor in the heater/air conditioner compartment. This compartment is location underneath the dashboard. This is the part that allows the heater blower motor to change the fan's speed.
its next to the blower motor
the heater resistor needs to be replaced it is mounted in the heater box next to the blower motor
the switch, or the blower motor resistor, or blower motor usually it the last two at one time