The 2001 Kia fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be near the back of the engine.
The fuel pressure regulator, on a 2001 Kia Rio, is located near the fuel injector pump. The pressure regulator can be found on the top of the engine.
The 1997 Cadillac Deville fuel pressure regulator can be found on top of the engine. The fuel pressure regulator will be near the fuel injector pump.
The starter relay switch is in the same location on both the 1996 and the 1997 Dodge Avenger. The starter relay switch can be found in the fuse box.
The 1985 Chevrolet S 10 blazer fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be near the fuel injector pump.
All that info can be found in the owners manual.
A water pressure regulator can be found in many of the common department stores. Costco, Walmart and Target are all options to find this for purchase.
Found the answer: The voltage regulator on a 98 Dodge RAM 1500 is NOT in the alternator. The alternator specifically states that the voltage is "Externally Regulated". In this vehicle the voltage regulator is built into the computer of the vehicle. To repair a bad voltage regulator in the computer you can either replace the computer or bypass the computer using about $50 in parts (ask your mechanic). Hope this helps.
I have a 1995 Avenger and it use to shut off randomly when driving. I finally found out it was the wire harness and replace it. Since then, 3 years ago, it has not happened since. Hope this helps. Chris
There are 2 different designs for the fuel regulator. It can either be found at the end of fuel rail with vacuum hose, or is built into the fuel pump.
95-2000 Base model Avenger and Chrysler Sebring coupe had the 2.0 liter 4 cylinder, 4g63 motor, rated at 140 bhp. This engine was built by Chrysler and also found in the 95-99 naturally aspirated Mitsubishi Eclipse RS and GS. 95-2000 Dodge Avenger ES and Chrysler Sebring LXi coupe had 2.5 liter V6, rated at 163 bhp
To maintain the pressure of 1 bar in a pipeline you would normally employ a regulator which has a diaphragm which works a needle valve balanced against an adjustable spring. An example of the use of a regulator would be the ones found on propane cylinders to regulate the gas pressure.