ive heard its in the fuse box. does anyone know where there factory keypad entry is for a Lincoln zephyr besides in the manual
It's in the trunk, next to the air ride shut off switch, has the factory code right on it. Actually, the code in located on the Computer Module.
where on my 2004 freeport can I find the computer module
I have a 1998 and the code is in the back where your jack and accessories are.
Cannot be diabled without removing the keyless entry module
How do you find the factory set keyless entry code for a 2004 Eddie Bauer Explorer
You will have to get ahold of a ford deal and give them your vin # i believe. I had the same problem when i bought my 2004 ls ;).
The keypad code is usually on a plastic card in the owners manual, or located near the top right hinge on the tail gate when open. It will be on a with adhesive tag. Normally 5 digits. Hope this helps
if you are talking about the keypad entry module it is behind the rear seat on the drivers side pull the backrest off the seat then pull away the carpet its right there (the code is also on the module) if you are talking about the keypad entry module it is behind the rear seat on the drivers side pull the backrest off the seat then pull away the carpet its right there (the code is also on the module)
i have a ford expedition .mine was under driver side dashboard .get down by gas peddle and look up with a flashlight .check there. >:)=
If it doesn't have a keypad on the door, it definitely doesn't have RKE, if there is a keypad chances are good its got it, and if not an RKE transciever from a junkyard tied into the existing wiring will do the trick Since the trunk also may be released by the remote keyfob....open the trunk and look at the interior hatch latch....if it has a wiring harness going in to the latch assembly....it probably will respond to a remote keyless entry
look behind glove box ,there is a 5 digit code on a black box in large black letters on a black module on the right hand side
There is a box located under the dash on drivers side usually mounted on the fire wall. This is your keyless entry control center. The code is printed on a label attached to that box. Hope this helps.