0
Add your answer:
Earn +20 pts
How do you disable anti theft 1998 Chrysler Sebring?
The factory alarm can not be disabled. It is reset by unlocking the car with the remote or with the key in the door.
How do you by pass the anti theft for a Chrysler Cirrus?
You can not bypass the factory alarm. It is built into the computers on the car.
How do you disable the anti theft system on a 1999 Chrysler town and country?
The factory theft alarm can not be disabled. It is disarmed by unlocking the doors with a key or the remote.
Does a 2000 Chrysler 300m have a factory installed alarm?
It could. Most 300's did. It also has a chip key theft deterrent system.
Is there a reset button to Chrysler town and country van for anti theft system?
No. The factory alarm is reset with the remote or by turning the key in the door locks.
Where is the anti theft system box located in a 1997 Chrysler lhs?
The factory system is not one "box". The engine computer and body computer work together to provide the theft alarm functions.
What is the little red light on dash of the sebring 2007?
It is an indication of a problem in the chipped key or theft alarm system.It is an indication of a problem in the chipped key or theft alarm system.
Can a 1997 Chrysler town and country ECM fit in a 1996 Chrysler town and country and work?
If the same engineand, if both either have theft alarm or neither have theft alarm then it may work.
Does the 2001 Chrysler Sebring have theft locator in it?
It was not built with one.It was not built with one.
How do you disarm the theft system in a 97 Chrysler Sebring convertible?
Unlock the door with the key or with the remote.
Is there a computer under the dash on the passenger side on a 1999 Chrysler Sebring will it keep car from running?
The body computer is on the back side of the dash fuse box. It is one of the computers in charge of the theft alarm. That can cause a no start.
How do you reset the factory anti-theft system in a 2000 Chrysler Sebring LXI?
Tried the suggested key tricksy with no joy. Disconnected battery cable for 10 min. After re connect, all back to normal
