The egr position sensor is made into the egr valve. Look for the egr valve and you will find a plug with wires plugged into the egr valve. These wires are for the position sensor and they go back to the ecm ( engine control monitor)< computer> James= 15 year Mazda tech just a tip= with engine COLD,reach under valve and press on plunger and see if it moves freely(not easy) but freely. Hope this helps.
Were is the egr on a 1992 mazda protege
"Intake Valve Timing Control Position Sensor, RH Bank 2" wouldn't think it would be too much to fix on this car.
where is the modulator vavle on my 1994 Mazda protege dx?
lick it
Were is the egr valve on a 99 Mazda progege 1.8
Sensor is located on the top part of valve cover at the front nearer the drive belts. Three wire connector to it has wire colors Blue, Black w/ Red stripe, and White w/ Red stripe.
The cam sensor is located on the left side of the engine (as your looking at it) on the valve cover. It is the only sensor that is located on that side on the upper part of the engine.
On my 1997 Protege a hose runs from the valve cover to the air intake assembly. Where the hose connects to the valve cover is the PCV valve.
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor
how much does it cost to replace to egr valve on the 2002 mazda protege
behind the engine on the firewall