A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.
The vehicle speed signal comes from the ABS sensor on top of the rear axle.
how do change brake pads on a 2002 dodge pickup 4x4
If you are asking about the 2.0L engine....the ECM was changed to what is called a NGC and the crank and tone wheel(pickup for crank position sensor) was changed. Also, the blocks are not interchangeable due to the position of the crank sensor was changed. It may be possible to change the crank and and sensor then extend the harness to reach the front of the engine where it was move from the rear starting in 2003 but this would be alot of work. Everything else on the engine should changeover fine.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
location of a crank shaft sensor on a nissan frontier 2002
The EGR is not the problem The tone ring on the crank for the crank position sensor is different and the engine will not start.
It is on the left front side of timing cover behind the balancer.
It is in the top rear of the bell housing,
A 2002 Dodge does have a cam sensor, but the 318 was not offered after 2001.
2002 ford crown Victoria how to repair crank sensor?
there is a sensor that is called a cam positioning sensor it is attached to the engine block which gets pretty hot try changing it. also there is one for the crank.