0
Add your answer:
Earn +20 pts
Where is the crank sensor located on a 92 Ford Tempo?
The 92 tempo doesn't have a crankshaft sensor. However the multi-port fuel injected models do have a Camshaft Position Sensor located near the distributor.
Where is the crank angle sensor on a 92 eclipse?
the cam angle sensor is the crank angle sensor it preforms both jobs
WHERE crank sensor 92 olds achieva?
It is located behind the harmonic balancer, also called the vibration dampener.
You put a new crank sensor in your 92 Buick and now its like its out of time?
You put a new crank sensor in your 92 buick and now its like its out of time?
If a 92 Jeep Cherokee will crank over but will not start what is the problem?
probably crank sensor, they are famous for that
93 to 92 Saturn engine change?
No this will not work. Crank shafts are different
Where is the crank sensor on a 92 150 dodge truck 318?
The "crank" sensor is the pickup plate under the distributor cap.The "crank" sensor is the pickup plate under the distributor cap.
Where is the LAF sensor located on a 92 Honda Civic?
Where is the LAF sensor located on a 92 honda civic?
Will 92 park avenue start with bad cam sensor?
No it will not start need to change the cam sensor & crank sensor!
Where is the O2 sensor and crank sensor located on a 91 Chevy Lumina 31L and is it fairly simple to replace yourself?
I have a 92 lumina with a 3.1 and I found the crank sensor to be located on the passenger side of the engine in the back of the engine NOT on the side of the engine below the knock sensor. Hello, in my experience, all O2 sensors are located in the exhaust just after the manifold. It appears easy enough to change. If it is the crank position sensor you are looking for, take a look around the main pulley at the bottom of the engine, you may see a square-ish component located close to the actual pulley wheel, this would be the crank position sensor, it should have wires connected to it.
Can you put a '93 Saturn engine in a '92 Saturn?
Saturn engine interchangibility.yes, by all means you can, the only thing is ..you have to match the ignition modules to the crankshaft. i.e. use a 93 module for the 93 crank and a 91-92 module for a 91-92 crank. there is a timing difference built in to the module for the crankshaft notches. that's about it. everything else will work.
92 ford ranger has no spark new module crank sensor?
its junk! crush it!
