Wiki User
∙ 15y agoIf you are asking where MIL is it is under hood on passenger side Blue/Yellow wire and Black wire. As far as timing notch on crank pulley,paint white, connect timing gun,8 degrees BTDC @800 rpm,if off loosen distributer bolt and adjust accordingly. This is assuming all other components are in working order timing belt etc.
Wiki User
∙ 15y ago10 degrees Before top dead center at idle, with warm engine, and E1 and TE1 shorted on the diagnostic connector.
the timing marks are located next to the top left side of the crank pulley
In a 2002 Ford Ranger : The 2.3 liter DOHC four cylinder engine has a timing CHAIN
what is the timing specs for a 95 geo tracker
Where is the timing connector on a 1995 gmc sonoma
The 2003 Chevrolet Tracker 2.0 liter 4 cylinder must have a timing CHAIN The Gates website does not list a timing belt for it
It requires that two terminals in the diagnostic connector be shorted and the engine run with an inductive timing light. As the engine computer can be damaged by the incorrect shorting of terminals I recommend getting a manual or a printout of a manual that shows the correct way to do this.
repair timing chain on 2000 chevy tracker
The timing connector is in the pasenger side under the carpet shuld be a brown cable
ground the diagnostic connector under the dash , set the timing , then unplug connector
The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.
Timing connector is located rightside passenger floor where the carpet meets the firewall inside