Its behind the glove box disconnect the negative battery cable remove the glove box assembly,lower right side instrumental panel trim cover and right cowl trim panel,as required.disconnect the blower lead wire connector If the vehicle is equpped with air conditioning the 2 vacuum lines from the recirculation door actuator and postition the actuator aside remove the 5 screws from around the blower housing and separate the blower housing from the unit remove the 3 screws that secure the blower assembly to the heater or air conditioning housing and remove the assembly from the unit.remove the fan from the blower motor by removing the spring type retaining ring from the center of the blower wheel.note the location of the fan-to-blower motor assembly for correct installation
IT IS LOCATED UNDER THE WIPER COWLING BEHIND THE WASHER BOTTLE AND HAS TWO SCREWS HOLDING IT IN
On my 91 its behind the engine in the center of the firewall
The blower motor on a 1992 is located under the hood. It is on the firewall on the passenger side.
The problem is most likely a faulty blower control module.
It is located on the blower motor housing and is white in color. You have to take the blower motor assembly out as far as I know to get to it.
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
Probably the blower motor resistor is shot.
under the blower motor housing. to the right
87 octane unleaded
Yes. First check to see that you have 12 volts to the blower motor. If yes, blower motor has probably failed. If no, it may be the blower motor relay or there is a speed control resister pack causing your problem.
The blower motor is on the right side of the engine compartment on the firewall.
usually mounted on or next to blower motor