ABS Sensor It takes two minutes to remove it, only one, very small bolt holds it to the hub and I believe it is a hex head drive you need to remove it. Just remove it, clean up the area around the hole and slide the new one in and hook it up to the harness. You might need some solvent to remove rust on the bolt if there is any, and then some anti-seize on the bolt when you replace it. I removed both of my front sensors as part of a lower ball joint replacement that I did (removing the hub entirely). The sensor is easy to replace. Remove hub nut and rotor shield to access the ABSsensor bolt, according to my manual
tell me how to replace a starter in a Lincoln navigator"?
Air leak.
On a 1999 Lincoln Navigator : If it is equipped with the six disc C/D changer , it is in the center console
On a 1999 Lincoln Navigator : The fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell , behind the kick panel ( according to the Owner Guide )
It is a black box located in the middle of the fron dash
According to the 1999 Lincoln Navigator Owner Guide ( 5W-30 )
on a 1998 it is located under compressor r/f fwd wheel well
On a 1999 Navigator it is located right up under the hood where the passenger headlight is. Needs to move from left to right...
According to the 1999 Lincoln Navigator Owner Guide : ( 113.6 liters / 30.0 U.S. gallons )
It is located on the reciever\dryer by the passenger side firewall.
On a 1999 Lincoln Navigator : The Mass Air Flow sensor is between the engine air filter and the big engine air intake tube ( it is INSIDE the round shaped plastic housing )
On a 1999 Lincoln Navigator : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle