answersLogoWhite

0


Best Answer

The solenoid, as well as the related valve, are inside the transaxle valve body, which is inside the transaxle fluid pan. I'm not sure if it's the lower pan or the side pan.

User Avatar

Wiki User

βˆ™ 16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the TCC Solenoid Valve on 1998 Olds Intrigue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there a transmission valve body on an Olds Intrigue?

Yes, in the transmission.


How do you change 1998 Olds Intrigue?

Change what?Change what?


Cost to replace O2 Sensor in 1998 Olds Intrigue?

$300 with labor


1999 Oldsmobile Intrigue Service engin soon?

What does 'service engine soon' light mean on a 1998 olds intrigue?


Where is the Location of the Engine Control Module For a 1998 Olds Intrigue?

Behind the glove compartment.


What other vehicles are interchangeable with 1998 Oldsmobile intrigue?

Most parts on the 1998 through 2002 Olds Intrigues are interchangeable.


How do you clean EGR valve on a 98 V6 3.8L Olds Intrigue?

After removing an EGR valve from the vehicle, the valve can be flushed with carburetor cleaner. If the valve still sticks then a replacement will be needed.


Where is the computer in a 1998 Olds Intrigue?

In the right kick panel. On my 98 Intrigue it's it the engine compartment in the black box connected to the air filter.


Where is the PCV valve located on a 1998 Olds Intrigue?

The PCV valve on a 1998 Oldsmobile Intrigue is located under the MAP sensor. If you remove the large plastic cover with 3800 written on it and look to the left side of the engine there is a sensor marked (Pressure Sensor) with 3 wires going into it. Unplug that sensor and turn it counter clockwise and lift it off and you will see the PCV valve under it. Here is a picture to go along with my answer. http://autorepair.about.com/library/illustrations/bl795lib.htm


1999 Olds Intrigue stalls when at idle sometimes. rpm jumps or stalls when I put it in reverse Runs great when my foot is on the gas over 1000 RPM. What is going on here?

I have a 1998 olds Intrigue and mine started doing that it was the crank shaft position sensor


Can you skip removing the PS Pulley and just remove the entire pump to access the WP Bolt?

This is on a 1998 Olds. Intrigue 3800 V6


Where is the camshaft sensor in 99 Olds intrigue?

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.