answersLogoWhite

0


Best Answer

You should find it right next to your oil fill and power steering reservoir , going into the valve cover under the edge of the air intake ! if you have a single overhead came it would be on the front drivers side between #3 & #4 intake ports Good Luck ! P.S. Its PCV (positive crankcase ventilation)

User Avatar

Wiki User

19y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the PVC valve on a 1998 Dodge Neon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is a PVC valve located in a 1998 dodge ram 1500?

It is the small plastic elbow that is on the top of the valve cover.


Where is the fuel filter and the PVC valve on a 1998 dodge stratus?

The Fuel filter is above the gas tank.


Where is the PVC valve located on a 2000 Dodge Dakota 3.9?

It is in the top of one of the valve covers.


Where is the PVC valve in a 2002 Dodge truck?

On my '02 Dakota the PCV valve is on the driver's side valve cover. .


How easy is it to replace PVC valve on 1998 explorer 5.0 engine?

how remuve and remplece pvc


Where is the PVC valve on a 1998 Chevy S-10?

There is not one.


Where is the PCV valve on 1999 subaru legacy outback?

where is the pvc valve on a 1998 suaru forester?


Where is the pcv located on a 1998 firebird?

The PVC valve on a 1998 firebird is on the passenger side. It is on the valve cover about halfway between front and back.


Where is the PVC located on your dodge ram 1500 5.9L?

Passenger side valve cover


Where is PVC valve on 1998 cavalier?

it is a hose on the engine, close to the brake fluid. screw the hose off, then you can pull PVC out.


Where is the PVC valve on a 1998 Mercury villager?

It mounts to the throttle body assembly.


Where is the PCV valve in 1998 Ford Expedition?

PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. # Install the hose.