Some of the 2000 models have a PCV valve on the back of the valve cover. The other models do not have a PCV valve, but use an oil/air separator instead.
There is a rubber elbow on both ends of the metal pipe that connects to your PCV valve.
I had this problem for 2 yrs before I found out that the PCV valve grommets were bad and had holes in there. I'm guessing that you are also burning alot of oil fast too. Check the pcv valve rubber fittings. Good luck
The PCV valve on a 1998 Oldsmobile Intrigue is located under the MAP sensor. If you remove the large plastic cover with 3800 written on it and look to the left side of the engine there is a sensor marked (Pressure Sensor) with 3 wires going into it. Unplug that sensor and turn it counter clockwise and lift it off and you will see the PCV valve under it. Here is a picture to go along with my answer. http://autorepair.about.com/library/illustrations/bl795lib.htm
PCV Valve is located near front of hood on the engine block between the fuel injectors.
The PCV valve for a 2000 Lexus rx300 is on the passenger side of the engine. It is on the valve cover near the back.
Under the big cover, there is a plastic plenum (aka upper intake manifold). In the end of this is a spring loaded device which contains the PCV valve. If you replace the PCV, take care to reuse the o-ring and spring which are present. If you miss either one of these, you won't like the loud noise created by your engine. :)
The PCV valve on a 2000 V6 Camry is found near the engine. More specifically, it is located on the top of the valve cover.
THERE IS NOT ONE.
Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.
The PCV valve is located in the rear valve cover,just behind the throttle body
The PCV valve is located in the rear valve cover,just behind the throttle body