They are normally found on the left or right side valve cover
I was told on 2008 avalanche, should be same on 2007 (not sure) to replace the whole left side valve cover. The PCV is build in in cover ?
Harold Sebring died on 1968-07-26.
In the gas tank? I have an '07 and that's where it is in mine. Chrysler does not use inertia/reset switches.
I printed coupons off the Chrysler website which was for $ 89.00 and took my 07 sebring to the dealer to get a tune up ..try it
The expansion valve is located between the evaporator and the high and low pressure line connections. It is in the firewall behind the engine. Follow the hoses to the passenger compartment and they will terminate on the expansion valve.
They are inside the intake manifold.
IAT stands for Intake Air Temperature sensor, and it is located on the valve or hose coming for the air filter box. it is a plug so it snaps in and out.
Either the trunk is open, or the trunk ajar switch has failed.
cold intake is 0.003 in or .07 mm cold exhaust is 0.003 in or .07 mm
There are two. The FICM fuel injection control module is located on top of the drivers side valve cover and the PCM powertrain control module is located in the drivers side finder behind the battery.
Remove EGR valve and inspect for blocked or restricted passages.