answersLogoWhite

0


Best Answer

I am pretty sure there are 2 of them. They are on the exhaust near the engine and on the catalytic converter. Look for a single wire.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the O2 sensor located on a 94 ford bronco?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Were is the crank shift sensor at on a 94 ford ranger 4.0?

Where is the crank sensor located on a 94 ranger 4.0 motor


Where is speed sensor located on a 94 bronco?

The speed sensor is located in the rear end on the driver's side, right next to the drive line. There is a wire connector that needs removed, and then one bolt and the sensor pulls right out.


Where is the crank shaft positioning sensor located on a 94 ford probe?

2.0ltr its in distributer


Where is the crankshaft position sensor for a 94 Ford Explorer?

The crankshaft position sensor is located on the front of the engine. It is just to the left of the crankshaft pulley.


Where is the EEC relay located on a 94 ford bronco?

ECC relay is in a box under the hood on the drivers side. open the lid and look at the inside of the cover and there will be a diagram of where each relay is located.


How do you replace a speed sensor on a 1994 Ford Explorer?

how do you replace the overdrive sensor on a 94 ford explorer


Is the MAF sensor on a 94 ford ranger voltage?

No it is not.


Where is 94 ford 7.3 throttle pos sensor location?

On a 94 Ford 7.3, the throttle POS sensor is on the throttle body. It is on the opposite side of the throttle linkage.


Where is the speed sensor for Ford Ranger 1993 located?

It should be in the tail shaft of the transmission. That's where mine is on 94 auto transmission.


What kind of brake fluid does a 94 Ford bronco take?

DOT ( 3 ) brake fluid


Where is MAF on 1993 ford bronco?

'93 models had speed-density, not MAF. MAF was started in '94


Where is the knock sensor located on a 94 3.0l v6 Ford Ranger?

I'm not a mechanic / technician but the engine wiring schematic for the 3.0 liter V6 engine in a 1994 Ford Ranger that is in my Chilton's repair manual does not show a knock sensor