0
The 4 cylinder 1994 Ranger uses a MAF sensor, not a MAP sensor. It is located very close to the air cleaner. Air flows through the air filter, then past the MAF sensor, and then into that long, odd-shaped black plastic tube to the throttle body. You can find the MAF sensor very easily by locating the air filter and then looking for an electrical fitting with some wires going to it. If you remove the MAF aluminum-body sensor..the only thing you can do for it is clean it; CAREFULLY spray some of Radio Shack's Tuner cleaner into the open port in the middle. DON'T STICK any objects down there as you can break the heating element inside the port. Use only a cleaner that leaves no residue and after let dry 15-20 min. If your truck does have a MANIFOLD ABSOLUTE PRESSURE (MAP) sensor it should be on the intake manifold or connected to it.
Add your answer:
Earn +20 pts
Where is the map sensor 1994 ford ranger 3.0?
The 1994 Ford Ranger pickup truck map sensor is located behind the dashboard, on the passenger side of the passenger compartment. The map sensor is contained in a dust free box.
Where is the low oil level sensor unit located on a 1994 ford ranger?
It should be located in the oil pan. On my ranger its on the drivers side.
4.0 L 1994 Ford Ranger map sensor location?
looking for an answer to this question "Where is the MAP sensor located in a 6 cylinder Ford ranger 1994 Help! www. motorcraft. com (no spaces) does not list a MAP sensor , it shows an AIR MASS SENSOR which I assume is the MASS AIRFLOW SENSOR which would be mounted close to your air filter housing
Where is the knock sensor located on a 94 3.0l v6 Ford Ranger?
I'm not a mechanic / technician but the engine wiring schematic for the 3.0 liter V6 engine in a 1994 Ford Ranger that is in my Chilton's repair manual does not show a knock sensor
Where is the camshaft position sensor located on a 2002 ford ranger?
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
Where is the IAT sensor on a 1994 Ford Ranger?
According to www . motorcraft . com ( no spaces ) the IAT sensor is a thread in type for the engines in a 1994 Ford Ranger - so threaded into the upper area of the intake manifold somewhere
Were is the crank shift sensor at on a 94 ford ranger 4.0?
Where is the crank sensor located on a 94 ranger 4.0 motor
Where is the map sensor located on a 1988 ford ranger 2.9l?
On the engine.
Where is the Plug for the sensor read out on a 1994 Ford Ranger?
under the hood driver side
Where is the front speed sensor ring on a 1998 Ford Ranger?
The 1998 Ford Ranger speed sensor ring can be located on the passenger wheel. The speed sensor ring will be on the inside of the brake rotor.
Where is the Location of map sensor on 1994 460 ford?
The map sensor is located on the intake manifold of a 1994 Ford. It could also be located on the plenum by the throttle body.
Where is the camshaft position sensor located on a 1999 ranger 4.0 v-6?
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine
