The Electric Fuel Pump assembly is located inside the fuel tank. Electric Fuel Pump Removal & Installation 1. Disconnect the negative battery cable. 2. Relieve the fuel pressure. 3. Raise and support the vehicle. 4. Remove the fuel tank; refer to the procedure outline in this section. 5. Remove the fuel pump retaining bolts. 6. Remove the fuel pump. To Install: 7. Thoroughly clean the fuel pump-mounting flange. 8. Install a new gasket and place the pump into the tank. 9. Ensure that the fuel tubes face toward the fuel rail and tighten the retaining bolts to 80-107 inch lbs. (9-12 Nm). 10. Install the tank as outlined in this section. 11. Tighten the fuel tank bolts to 66-91 inch lbs. (7.6-10.4 Nm). 12. Tighten the fuel tank straps bolts to 22-30 ft. lbs. (29.7-40.7 Nm). 13. Tighten the skid plate bolts to 9.3-12.7 ft. lbs. (12.7-17.3 Nm). 14. Connect the negative battery.
The 1986 ford f150 has two fuel pumps. There is one pump mounted inside of each fuel tank.
where is the fuel filter on a 2002 ford explorer
Most likely in the fuel tank
Fuel pressure on a 2002 Ford F150 4.2 V6 should be around 40 PSI. When pressure drops too low, fuel is not vaporized properly.
2002's is on the bottom side of the Throttle Body
Where is the location of the fuel pump relay in the 1997 Ford F150.
What is the fuel capacity on a Ford F150
IN the gas tank.
1997 ford f150 fuel pressure specs
Look just in front of the radiator on the driver's side.
There are images available online to help you see where the Fuel reset switch on a 1986 Ford F150 is.
Probably under vehicle - follow fuel line from tank