4.2L, 4.6L, 5.4L and 6.8L Engines 1. Disconnect the negative battery cable. 2. Remove the vacuum hose from the EGR valve. 3. On the 4.6L engine, remove the nut and brake booster bracket. 4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube. 5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve. 6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold. 7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold. To Install: 8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts. 9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm). 10. Connect the vacuum hose to the EGR valve. 11. On the 5.7L engine, install the DPFE sensor. 12. On the 4.6L engine install the brake booster bracket and the retaining nut. 13. Connect the negative battery cable.
The EGR valve on a 92 E-150 is located on the passenger side front of the engine. The EGR valve is on a pipe just behind the alternator.
depends on engine most times in back on to of engine
The EGR valve is located in the center of the engine on a F150 Lariat 5.4 liter. It is near the firewall.
Under hood, center, upper engine area, mounted in rear of valve cover
Under hood, center, upper engine area, mounted in rear of valve cover
It is located at the passenger side rear of the valve cover under the intake manifold.
The PVC valve is located on the back of the engine, behind the throttle body. Mine is a 300 engine (6 cylinder) should be in the same location on an eight cylinder as well.
The PVC valve is located on the back of the engine, behind the throttle body. Mine is a 300 engine (6 cylinder) should be in the same location on an eight cylinder as well.
There is no modulator valve on the outside of this transmission.
it is located on the passenger side valve cover
Under hood, center, upper engine area, top of engine, mounted in passenger side valve cover
the egr valve is located near the firewall in the center of the engine it has afitting coming off of the exshust and going to it and alittle suction hose on top of it. hope that helps you