You don't. The pulley is pretensioned by the manufacturer. If the belt tension is incorrect, the pulley must be replaced.
If you're standing at the front of the truck and looking into the engine compartment the tension pulley is on the left side about half way down.
The tension pulley is centerline with the engine and at the very top of the belt routing.
No
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
The 1998-2000 Chevy Metro with 1.0L engine has an oil capacity of 3.5 quarts.
TH125 three speed.
it is 37
i do not know...
Behind the water pump pulley. The pump is smaller than the pulley so the pulley hides it.
Look on the passenger front side of the engine, you will see pulley attached to a short arm with a square hole. That is the tensioner and tensioner pulley
It is inside of the transmission.