Cooling SystemEnsure that the engine is completely cool prior to starting this service. 1. Remove the recovery tank or radiator cap. 2. Raise and support the vehicle. 3. Place a drain pan of sufficient capacity under the radiator and open the petcock (drain) on the radiator. è Plastic petcocks easily bind. Before opening a plastic radiator petcock, spray it with some penetrating lubricant. 4. Drain the cooling system completely. 5. Close the petcock. 6. Remove the drain pan. 7. Lower the vehicle. 8. Determine the capacity of the cooling system, then property refill the system with a 50/50 mixture of fresh coolant and distilled water. 9. Leave the recovery tank or radiator cap off to aid in bleeding the system. 10. Start the engine and allow it to idle until the thermostat opens (the upper radiator hose will become hot). The coolant level should go down, this is normal as the system bleeds the air pockets out of the system. 11. Refill the system with coolant to the proper level. 12. Turn the engine OFF and check for leaks.
To drain the radiator on a 1999 Ford Expedition, place a bucket under the radiator. Unscrew the radiator drain hose or valve on the bottom of the radiator. Remove the radiator cap.
On a 2002 Ford Expedition : The thread on cap on the engine coolant reservoir is the pressure cap / radiator cap
Where is the drain for the coolant on the radiator of a 2002 Ford Explorer sport (v6). Thanks.
follow the upper radiator hose where it goes into the top of the motor and it will be right there.
The engine coolant drain plug, on a 1998 Ford expedition, is located on the bottom of the radiator. The drain plug will come out by turning to the left.
Where_is_the_radiator_petcock_on_2000_Ford_Focus
2002 t/bird cooling drain pug location
The bottom of the radiator is exposed and has a plastic nut that is loosened with a crescent wrench. Once that is loose, the coolant will drain from the center of that nut.
The radiator drain plug is on passenger side of the radiator tank at the bottom. You can use pliers to loosen it. Be careful that it does NOT come out, only loosen it enough to drain the anti freeze.
How do you replace a radiator on 2003 ford expedition?
Drain the water from the radiator. Remove the radiator hoses. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
The 2002 Ford Expedition has 16 valves.