It is located in the throttle body.
The 1985 Chevrolet S 10 blazer fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be near the fuel injector pump.
Fuel pressure regulator is located under the upper intake cover
Not sure what pressure control solenoid is, could it be the fuel pressure regulator?
Assuming this is a 4.3L engine, the fuel pressure regulator is located under the upper intake manifold. The upper intake manifold must be removed to gain access to the regulator.
A 4.3L engine has the fuel pressure regulator located under the upper intake manifold attached to the bank of fuel injector poppets.
there is none.there is a pressure regulator however.and there is a tank sensor sometimes that measures pressure in the tank. but not on all vehicles.
We need to know the year and engine size to answer that one.
Fuel Pressure Regulator is located on the fuel rail.Ford ExpeditionsFuel Pressure Regulator1. Disconnect the negative battery cable.2. Properly relieve the fuel system pressure.3. Remove the air cleaner outlet tube(s).4. Remove any necessary components to access the pressure regulator.5. Disconnect the vacuum hose from the pressure regulator.6. Remove the pressure regulator attaching screws.7. Remove the pressure regulator from the fuel rail.To Install8. Discard the O-rings on the pressure regulator and replace them with new ones.9. Lubricate the O-rings with clean engine oil.10. Install the regulator into the fuel rail and tighten the retaining screws.11. Connect the vacuum hose to the regulator.12. Install any components removed to access the regulator.13. Install the air cleaner outlet tube(s).14. Connect the negative battery cable.
If you have the central injection system, you regulator is inside the plenum, next to the spider assembly. Takes about 20 minutes to get to it.
Assuming you have the 4.3L engine it would be located under the upper intake manifold. After removing the upper intake manifold you will see the fuel pressure regulator attached to the bank of injector "poppets".
how do u replace fule pressure regulator in 94 blazer vortec