I would only use the wiring loom from a MK1, as the MK2 wiring could be completely different!
open the ashtray. gently pull it out and voilá! an OBD-2 port :)
The data link connector is located under dash panel, center
Behind a 6" X 2" panel in the centre console just above the ashtray
To right of ashtray and above the lighter there is a small removable panel aprox 2"x2"gently remove it from around the edges and it will come off to reveal the diagnostic plug port.
The 2000 Acura TL OBD 2 port is above shifter
OBD 2 is 1996 and later. The diagnostic plug is always under the dash on the driver side.
Center of dash, below the ash tray is a slot 4 inches by 1/2 inch.
It is under the kick panel on the passegers side. Right by where the right foot would be. Remove this panel to expose two plugs the clear/white one is the diagnostic port. You want to bridge the two outer terminals. 1 and 3 with a paperclip. _____ | | _ _ _ 1 2 3
Mk VI, Vickers Mk VII, Tetrarch Mk I, Matilda Mk II, Matilda II Mk III, Valentine Mk IV, (A22) Churchill Sherman Mk VI, Crusader Mk VIII, Cromwell Comet I (A34) Centurion (A41) Archer
2 ford mondeo not blowing hot air air con works
bonjour je voudrai savoir comment on ouvre le capot d'une ford mondeo 2