0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the approximate location of a crankshaft sensor on a 1993 Chevy Lumina APV minivan?
on most cars it in the front at the bottom of the by the crank pully
Where is the fuel pump on a 1995 Chevy lumina apv?
in the gas tank
How can i tell what generation the 3.1 engine in my 1995 lumina van is?
The 1995 Lumina APV used a Generation II 3.1L V6 (Model LG6). The 1996 APV had a Generation III 3.4L V6 (Model LA1). 1996 was the last model year of the Lumina APV Van. http://en.wikipedia.org/wiki/GM_60-Degree_V6_engine#LG6
When was Chevrolet Lumina APV created?
Chevrolet Lumina APV was created in 1989.
Where is the vehicle speed sensor on a Chevy Lumina APV minivan?
The Chevrolet Lumina speed sensor can be found on the back of the transmission. The exact position of the speed sensor is dependent upon the year of the automobile.
How do you remove crank pulley 92 lumina van with 3.8?
I want to take off the pulley wheel off,from a 1992 chevy lumina apv van.
93 Chevrolet Lumina APV Where is the crank sensor located?
There is one behind the harmonicbalancer and crank pulley. There is also one on the backside lower center part of the engine that has a cover so you would miss it if you didn't know it was there. This is on the 3.8l. Hopes this helps.
How do you program a 1995 Lumina APV key fob?
To program any kind of key fob you have to take it to a dealership.
Where is the cruise control module located on 1995 lumina apv?
Drivers side, under the washer fludid container.
Where is the crankshaft sensor located on a lumina apv?
Itis mounted to the front face of the engine block right behind the crankshaft pulley and often covered by a small shroud. You can usually see the wires leading to the connector plug in that area, at bottom of the crank pulley.
How do you change carburetor on a lumina apv 93?
It does not have a carburetor.
Where is the ecm on a 1995 lumina apv?
it is behind the glove box on the passenger side. The lower dash panel must be removed to gain access.
