The stop lamp switch is on a bracket above the brake pedal.The stop lamp switch is on a bracket above the brake pedal.
Probably either a bad brake lamp switch, improper adjustment of the brake lamp switch or a bad turn signal switch.The brake lamp switch also contains the cruise disconnect switch, but often only the brake lamp portion will fail due to the higher current involved in running the brighter lamps. The switch develops resistance caused by carbon tracking on the contacts from the spark that's created whenever the switch changes states.Also, the brake lamp circuit runs through the turn signal switch. If the brake lamp contact in the switch goes bad, you can have a situation where the brake lamps won't light but the turn signals function properly.
if it isn't a fuse or lamp problem, check the brake lamp switch on the brake pedal, if you unplug the switch, and jumper the connection, and you have brake lamps, replace the switch...
See sources and related links below for the 2004 Jeep Liberty Brake Light Lamp Numbers.
brake lamp switch failure
Bulbs blown/Brake lamp switch inoperative
Yes if the wire is part of the brake lamp switch
Switch loose or faulty? Check if the switch is fitted to the brake pedal. Perhaps the bracket has worked loose.
If you mean the switch that turns on the brake lights when you put the brakes on , it is above the brake arm of the foot pedal.
on the clutch pedal, just like a brake lamp switch
C1295 means (Brake lamp switch circuit open). Most likely a bad brake switch on the brake peddle, or a bad capacitor between the 2 switches. .
Fuse, switch, wiring, ground circuit.