answersLogoWhite

0


Best Answer

it is on the vehicles intake box you will need to go to a parts store to buy a Ford tamper proof hex set to remove it make sure when you are replacing it that you replace the rubber o-ring that's around the inside of the sensor unless you have a v-6 model then it is part of the intake box and all you need is a screwdriver to releave the rubber hoses attached to it

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is a mass air censor in a 1993 ford probe?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your 1993 Ford Probe gt surge?

could be a number of things first tap on your mass air flow sensor while it is idling and if it lines out change it. or it could be your IAC (intake air control)


Where is the mass air flow on a 1997 Ford Probe?

The mass airflow sensor would be between the engine air filter and the big engine air intake tube


Location of mass air flow sensor 1993 ford RV?

on top of heater housing


Where is the mass air flow sensor 1994 Ford Probe?

it is behind the air filter box, before the curved duct that carries air to the throttle body.


What is a probe weight on earth if the probe has a mass of 100 kg?

On earth, 100 kg of mass weighs 980 newtons (220.46 pounds).


Where is MAP sensor located on a 1993 ford ranger?

WWW.MOTORCRAFT.COM shows remanufactured AIR MASS SENSORS ( mass air flow sensors ) for the 3 available engines on your 1993 Ranger , there are no listings for a MAP sensor


Why would a 1996 Ford Probe SE stall-pause when in gear neutral and appond-during acceleration?

Mass airflow sensor is dirty or needs replaced. Try that first.


Your 1991 ford probe gt turbo turns off when you come to a stop what could cause this to happen?

MASS AIR FLOW SENSOR, LOCATED ON THE FRESH AIR TUBE FROM AIR FILTER.


Why could a 1989 Ford Probe be cutting off when it idles too long even after changing the fuel filter?

Make sure your mass air flow electrical connection is connected tight.


Where is the speed sensor on a 1995 Ford Probe SE?

On the manual transaxle, the VSS (Vehicle Speed Sensor) is on the top rear of the transaxle, pretty much directly below the MAF (Mass Airflow) sensor.


Where is Mass flow sensor location for 2003 Ford Ranger?

The Mass Airflow sensor (MAF) is located between the air filter housing and the air intake duct. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.


Where is the mass airflow censor for 1997 Chrysler cirrus diagram?

95 through 2000 cirrus' do not have a mass flow sensor. I noticed that when I put a cold air intake on my 99 .