crank tool is in clips along the top of the frame in front of the radiator,under the hood
The long scissor jack crank supplied with the vehicle is the tool for lowering the spare. Insert it into the hole in the back of the truck below the tailgate and locate it into the hoist socket. I think it's anticlockwise to lower.
how do i lower the spare wheel on a ford transit truck
The "crank" sensor is the pickup plate under the distributor cap.The "crank" sensor is the pickup plate under the distributor cap.
underneath the rear of the truck - lets down with a crank
a pickup and a truck are the same thing hence the term pickup truck a pickup can be a truck but a truck doesn't have to be a pickup.
It should be located under the truck, behind the rear axle.
The jack is located under the passenger-side rear seat, in the compartment under the seat. The shaft for the jack is also used to crank the chain lift that holds the spare tire under the truck bed. You will see a slot above the rear license plate where the round "hook" end of the shaft is inserted. The hook engages a split-head bolt that allows you to crank the spare tire down.
The mass of a pickup truck depends on the truck but the average truck is about 162 kg.
It is possible depending on what kind of pickup truck you own.
to remove spare wheel on 2001 f250, you will need the key that fits the crank on the spare wheel carrier the key fits the end of the jack handle and then fits into the wheel carrier to allow the lowering of the wheel if you do not have the key you can purchase a replacement from "McGard,Inc"(1-800-444-5847). you will need VIN number from truck to order new key and the key will cost about $25-00 there are several hundred different variations on the key, i have access to about 8 ford trucks and not one key would interchange with others
No pickup truck that is "cheap" is going to qualify as a "good" pickup truck. I would suggest spending the money on a high-quality pickup truck. It doesn't have to be luxury, but you definitely get what you pay for.
The spare tire is located under the rear of the truck. Insert the flat end of the tire iron into a hole located on the right side of the rear bumper and crank until the tired drops down to the ground.