Get under the car. Look for a wire connected to the wheel. That is it. The front can be changed easily by removing 1 bolt. The rear, remove the wheel and brake drum. There are 4 bolts(torx or star head bolts) & nuts that need to be removed. There is no need to remove the brake shoes. First check that the wires are making good contact at the master cylinder and havent come loose. Also check the fuses and wire harness for bad spots. Could also be calipers or a malfuction with the master cylinder assembly.
The horn is located in the center of the steering wheel on the 2000 Chevy Cavalier.
There is a problem with your wheel speed sensors. This is common.
it should be located right on the back of the wheel assembly
The low trac light in your 1998 Chevy Cavalier means your vehicle has low traction. Low traction means the sensors have detected wheel spin and the engine power reduces to prevent wheel spin. You may have a bad wheel sensor.
The traction control and the ABS both use the wheel speed sensors in the wheel bearings
its on the passerger side by the front wheel under the power steering.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
On my '96 Cavalier, the horn is located in the front driver side wheel well. I had to jack it up, remove the wheel, and then access panel inside the well to get to the horn.
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
speed sensors are located on front hubs remove the wheel and you will see what looks like a serated disk the sensors are located adjacent to these These sensors are for the ABS and do not control the speedometer. The vehicle speed sensor is somewhere on the transmition or transfer case. Exactly where I am also trying to find out.
The mount is located on the drivers side of the vehicle. remove wheel and plastic cover to access.
No