answersLogoWhite

0


Best Answer

A common problem with GM vortec engines is that they dont seal the knock sensors very well and moisture gets into them. the fix is to replace the sensor, and build a dam of rtv silicone around it, keeping water out.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would make a knock sensor go bad in a Chevy truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you check the knock sensor on 2007 Chevy Cobalt?

If a knock sensor was bad, the check engine light would be illuminated and the code(s) set would indicate so.


What is the sensor directly above the oil pan gasket next to the starter in my Chevy 350?

What year, and application? NEW ANSWER: That would be the knock sensor,


What is the blue wire by starter on Chevy pickup?

It would help to know the year, But I would say that it is the knock sensor wire and it should be pluged into the knock sensor that is screewed into the side of the engine block just in front of the starter.


Where would the knock sensor be located on a 2004 Mazda 6?

Where would the knock sensor be located on a 2004 mazda 6?


1997 Chevy crankshaft sensor location k1500 5.7?

I have a 1997 1500 chevy truck vtect engine and I hit a bump in the road and it would not start. What do this mean


Where is location of knock sensor 1991 Toyota truck with 3.0 3VZ-E?

The knock sensor is located in the block, under the intake manifold. You have to basically remove the top end of the engine to get to it. The pigtail which connects the sensor to the harness is usually the culprit. It is notorious for failing but after spending all the time and money for gaskets I would recommend replacing the sensor as well.


What is the cost to replace a knock sensor on a Nissan Altima?

If just the knock sensor need to be replaced. I would say no more than $150.00


Will a bad knock sensor stop a Volvo 240 from starting?

I have a 240 and with the knock sensor unplugged it will still start so I would have to say no.


What is Code 43 ESC on a 1989 Chevy Beretta and would that be the reason the car is not running?

thats your knock sensor ESC is Electronic Spark Control which governs timing.


Would the knock sensor stop the engine from starting?

No. It only senses engine vibration/knock.


How do you relocate of knock sensor Nissan 2004 Xterra?

A knock sensor is located in a specific area on the block or cylinder head in order to sense spark knock occuring and send a signal to the ECM to retard the timing. Relocating the knock sensor would defeat its purpose.


Would a 1996 Chevy truck 4l60e transmission fit in 1997 Chevy truck?

yes