Wiki User
∙ 14y agoA lacquer-based clearcoat. Enamel is never used for auto paint.
Wiki User
∙ 14y agoMixing clearcoat with paint, will ruin the paint.For enamel paints, make sure you use an enamel clearcoat. You should allow the paint to fully cure (at least a week) before attempting to apply the clearcoat. Never use a lacquer based clearcoat on an enamel based paint. It will ruin it.For lacquer based paint, you should only use a lacquer based clearcoat. The paint should be dry, but does not have to be fully cured, since the lacquer will wet the coat of paint below it anyway.
Yes. But you can't do the reverse. So if your primer is lacquer-based you can spray an over-coat of enamel on the top.
Lacquer can cause the paint to bubble or crack due to the very hot solvent that is a part of lacquer. If you want a clear coat over paint, a better choice is spar varnish over oil base paint and arcylic urethane over latex.
coat, finish, polish, shine, gloss, varnish, enamel, lacquer
No it will cause big problems. You should sand down to paint before adding a new coat of clearcoatAnswer: There is nothing wrong with putting a new coat of clear over old, as long as it is well sanded , and the underlying clearcoat is in sound condition. It is necessary to do it when spot- repairing a clear -over- base metallic paintjob.
i used clear ttop coat NYC nail polish XD
yes u can use clear coat on ur enamel paint but first u hav to put primer then paint coats two - three coats depending on the requirements and then apply the clear coat single or double as required and most important thing is drying time shud be given in between each coats.
Yes, a clear coat of lacquer can be used to refinish a Louisville Slugger bat. Once applied, you should let the bat sit for at least a few hours. This will allow the elements of the lacquer to effectively soak in, which will preserve the bat and give it a fine coat and finish. You can also use pine tar, however, this is only a temporary solution in keeping the bat smooth.
in theory yes however if you put a new layer on lacquer it may not be clear as in see through, so you better just try on scrap.. good luck.
A clear coat or more depending on what you have painted. This will chip the clear coat not your colour coat. For best protection a two pack clear that when cured ends up as hard as nails to protect the finished products colour from damage. It also will chip but gives a good protection for the colour coat. !
Use a straight enamel the wet sand it with 600 grit for hour and hours and hours and repeat for coat 2 clear coat can not be painted on with brush unless you a magic paint brush lol clear over clear does not work
By transforming your biometrics - like your eyes and face - into a single touchless ID, you can rely on CLEAR for a faster, safer experience, every time. CLEAR keeps you moving, without contact or crowds. Find CLEAR in 65+ airports, sports venues. cutt.ly/ejcsk1j