Want this question answered?
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
I have a 2005 chevy malibu and had the same issue... It's the fuel sensor.. Need to replace fuel system
I need the torque and secuense for the hea d bolts for a Chevrolet Malibu 2000 3.1
I need short circuit calculaion
If it's not leaking it doesn't need additional fluid.
i have a 1997 chevrolet Malibu with a po113 code. the car has been sitting up for about a one year can it just need to run for a couple of miles or what do i need to do?
snac ecm for codes then using code data you can determine which sensor kbutlrtech@yahoo.com
It is behind the starter, Will need to remove starter to service it.
you need a new battery usally every ten years there is probably a warranty on it chech it out
if it's a 4 cylinder then you need 4 plugs if it's a 6 cylinder then you need 6 plugs **********************KKODAL********************************
The 2000 Chevy Malibu engine oil capacity is dependent upon the type of engine. In general, the engine will require 4.5 quarts of oil.